![]() ![]()
L298N modules do not have built-in current. Large current can reach 3A MAX and continue current. Drive voltage 5V-35V, high working power to 46V. Package Included 2pcs L298N Motor Driver Controller Board Modules. 2.5A peak current per channel (2A continuous) The module can handle up to 2.5A peak per bridge or 2A continuous and 25W total power. PChero 2Packs L298N Motor Drive Controller Board Module, Dual H Bridge DC Stepper For Arduino Smart Car Robot. + More Info Including Updated Prices, Images and Customer Reviews – CLICK HEREĪffiliate Disclaimer: As an Amazon Associate, I earn from qualifying purchases. KEY FEATURES OF L298N DUAL H-BRIDGE MOTOR CONTROL MODULE: Drive 2 DC motors with speed and direction control. #L298N STEPPER MOTOR DRIVER CONTROLLER BOARD MODULE MANUAL DRIVERS#Two built-in H birdge high voltage and large current full bridge drivers can be used to drive the DC motor and stepper motor, r Having 15 pins as package, this chip has such features as high working voltage(maximum voltage up to 46V),large output current(instantaneous peak current up to 3A, continuous working current 2A) and 25W of rated power. Why CHOOSE PChero Motor Drive Controller Board Moduld? Reason 1: Use L298N for Main Chip L298N is a kind of high voltage, high current motor driver chip. Just wire up motors and power, this thing will work wonders. ![]() High Efficiency – Dual-channel H-bridge design, can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors.And it also use large-capacity filter capacitor and diode with freewheeling protection function, thereby improve the reliability of module. High Quality – Use L298N as the main driving chip, so the module has such features as strong driving ability, strong anti-interference and low calorific value.This module can use the built-in 78M05 to take power by driving the power section, but in order to avoid damage to the regulator chip, when use is greater than the drive voltage of 12V, use an external 5V logic supply. You can connect an input voltage anywhere between 5 to 12V to this pin. ![]() VS pin gives power to the internal H-Bridges of the IC to drive the motor. The L298N motor driver actually has two input power pins VS and VSS. Power to 25w.(NOTE: To avoid damage, please use an external 5V logic supply when using more than 12V driving voltage.) This module uses ST's L298N chip as the main driver, driving ability, low heat, strong anti-interference ability. The L298N motor driver module is powered through 3-pin 3.5mm-pitch screw terminal. Large current can reach 3A MAX and continue current is 2A.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |